|
How to Use:
To incorporate into Townsend Casting Resin: 1. Measure equal volume of A and B side of resin (see directions).
2. In a third cup, measure out the same volume of bronze power.
3. Pour ½ bronze powder into the A side cup and ½ into the B side cup.
4. Mix each well, wetting out the bronze powder.
5. Combine the A and the B into an empty, clean plastic container and mix thoroughly and continue following Casting Resin directions.
To dust on a mold: 1. Sprinkle a small amount of the bronze powder into a fully cured silicone rubber mold and rotate to dust the entire surface (just like dusting a cake pan with flour).
2. Pour mixed casting resin into the mold. The bronze powder will bond with the casting resin so that the outer surface of you mold will be bronze. Let cure. After de-molding, the surface can be polished (with 000 steel wool) and then patinaed with our Sculpt Nouveau patinas and finishes.
| 
